7 Del. Admin. Code § 1124-5.0
Current through Register Vol. 28, No. 1, July 1, 2024
Section 1124-5.0 - Compliance Certification, Recordkeeping, and Reporting Requirements for Non-Coating Sources01/11/1993
5.1 Initial compliance certification. The owner or operator of any facility containing sources subject to 5.0 of this regulation shall submit to the Department an initial compliance certification by November 15, 1993. The owner or operator of any new facility containing sources that become subject to 5.0 of this regulation after November 15, 1992 shall submit an initial compliance certification immediately upon startup of the facility. 5.1.1 The initial compliance certification shall provide at a minimum the following information: 5.1.1.1 The name and location of the facility.5.1.1.2 The address and telephone number of the person responsible for the facility.5.1.1.3 Identification of subject sources.5.1.2 For each subject source, the initial compliance certification shall also provide at a minimum:5.1.2.1 The applicable emission limitation, equipment specification, or work practice.5.1.2.2 The method of compliance.5.1.2.3 For each source subject to numerical emission limitations of this regulation, the estimated emissions without control.5.1.2.4 The control system or systems in use.5.1.2.5 The design performance efficiency of the control system.5.1.2.6 For each source subject to numerical emission limitations of this regulation, the estimated emissions after control.5.1.2.7 Certification that each subject source at the facility is in compliance with the applicable emission limitation, equipment specification, or work practice.5.1.2.8 The time at which the facility's "day" begins if a time other than midnight local time is used to define a "day."5.2 Reports of excess emissions. The owner or operator of any facility containing sources subject to 5.0 of this regulation shall, for each occurrence of excess emissions, within 30 calendar days of becoming aware of such occurrence, supply the Department with the following information, in addition to complying with any other reporting requirements mandated by the State of Delaware: 5.2.1 The name and location of the facility.5.2.2 The subject sources that caused the excess emissions.5.2.3 The time and date of first observation of the excess emissions.5.2.4 The cause and expected duration of the excess emissions.5.2.5 For sources subject to numerical emission limitations, the estimated rate of emissions (expressed in the units of the applicable emission limitation) and the operating data and calculations used in determining the magnitude of the excess emissions.5.2.6 The proposed corrective actions and schedule to correct the conditions causing the excess emissions.5.3 Requirements for sources using control devices.5.3.1 Testing of control equipment. By November 15, 1993, or upon startup of a new source, or upon changing the method of compliance for an existing source, the owner or operator of the subject source shall perform all tests and submit to the Department the results of all tests and calculations necessary to demonstrate that the subject source will be in compliance with the applicable section of this regulation on and after November 15, 1993, or on and after the initial startup date.5.3.2 Recordkeeping. 5.3.2.1 Each owner or operator of a source subject to 5.0 of this regulation shall maintain up-to-date, readily accessible continuous records of any equipment operating parameters specified to be monitored in the applicable section of this regulation as well as up-to-date, readily accessible records of periods of operation during which the parameter boundaries established during the most recent performance test are exceeded. These records shall be maintained for at least five years. The Department may at any time require a report of these data. Periods of operation during which the parameter boundaries established during the most recent performance tests are exceeded are defined as follows:5.3.2.1.1 For thermal incinerators, all three-hour periods of operation in which the average combustion temperature was more than 28°C (50°F) below the average combustion temperature during the most recent performance test that demonstrated that the facility was in compliance. The combustion chamber set-point shall be no less than that during the most recent performance test that demonstrated that the facility was in compliance.5.3.2.1.2 For catalytic incinerators, all three-hour periods of operation in which the average temperature of the process vent stream immediately before the catalyst bed is more than 28°C (50°F) below the average temperature of the process vent stream immediately before the catalyst bed during the most recent performance test that demonstrated that the facility was in compliance. The set-point for the process vent stream immediately before the catalyst bed shall be no less than that during the most recent performance test that demonstrated that the facility was in compliance.5.3.2.1.3 For carbon adsorbers, all three-hour periods of operation during which either the average VOC concentration or the reading of organics in the exhaust gases is more than 20% greater than the average exhaust gas concentration or reading measured by the organics monitoring device during the most recent determination of the recovery efficiency of the carbon adsorber that demonstrated that the facility was in compliance.5.3.2.2 A log of operating time for the capture system, control device, monitoring equipment, and the associated source.5.3.2.3 A maintenance log for the capture system, control device, and monitoring equipment detailing all routine and non-routine maintenance performed including dates and duration of any outages.7 Del. Admin. Code § 1124-5.0