2 Colo. Code Regs. § 407-6-12
Current through Register Vol. 48, No. 1, January 10, 2025
Rule 2 CCR 407-6-12 - ELECTRICAL1. Electrical equipment and circuits shall be provided with switches or other controls. Such switches or controls shall be of approved design and construction and shall be properly installed.2. Circuits shall be protected against overload by fuses or circuit breakers of the correct type and capacity.3. Permanent splices and repairs made in power cables, including the ground conductor, where provided, shall be:a. Mechanically strong with electrical conductivity as near as possible to that of the original;b. Insulated to a degree at least equal to that of the original, and sealed to exclude moisture; and c. Provided with damage protection as near as possible to that of the original, including good bonding to the outer jacket.4. Power wires and cables shall be insulated adequately where they pass into or out of electrical compartments. Cables shall enter metal frames of motors, splice boxes, and electrical compartments only through proper fittings. When insulated wire, other than cables, passes through metal frames, the holes shall be substantially bushed with insulated bushings.5. Telephone and low-potential signal wire shall be protected, by isolation or suitable insulation, or both, from contacting energized power conductors or any other power source.6. All electrical equipment or components must have a ground wire or be properly grounded.7. Battery charging stations shall be equipped with a separate ground conductor from the charging unit to the battery unit while charging.