Section 230.98 - Driving, trailing, and engine truck axles(a)Condemning defects. Driving, trailing, and engine truck axles with any of the following defects shall be removed from service immediately and repaired (see appendix A of this part for inspection requirements): (2) Cut journals that cannot be made to run cool without turning;(3) Transverse seams in iron or steel axles;(4) Seams in axles causing journals to run hot;(5) Axles that are unsafe on account of usage, accident or derailment;(6) Any axle worn½ inch or more in diameter below the original/new journal diameter, except as provided in paragraph (a)(7) of this section;(7) Any driving axles other than main driving axles with an original or new diameter greater than 6 inches that are worn¾ inch or more in diameter below the original/new diameter.(b)Journal diameter stamped. For steam locomotives with plain bearings, the original/new journal diameter shall be stamped on one end of the axle no later than January 18, 2005.