Statutes, codes, and regulations
Code of Federal Regulations
Title 40 - PROTECTION OF ENVIRONMENTChapter I - ENVIRONMENTAL PROTECTION AGENCYSubchapter C - AIR PROGRAMSPart 60 - STANDARDS OF PERFORMANCE FOR NEW STATIONARY SOURCES
Subpart BBBB - EMISSION GUIDELINES AND COMPLIANCE TIMES FOR SMALL MUNICIPAL WASTE COMBUSTION UNITS CONSTRUCTED ON OR BEFORE AUGUST 30, 1999
Appendix Table 8 to Subpart BBBB of Part 60 - Model Rule-Requirements for Stack Tests

40 C.F.R. § 60 app Table 8 to Subpart BBBB of Part 60

Download
PDF
Current through November 30, 2024
Appendix Table 8 to Subpart BBBB of Part 60 - Model Rule-Requirements for Stack Tests

To measure the following pollutantsUse the following methods in appendix A of this part to determine the sampling locationUse the following methods in appendix A of this part to measure pollutant concentrationAlso note the following additional information
1. Organics
Dioxins/FuransMethod 1Method 23aThe minimum sampling time must be 4 hours per test run while the municipal waste combustion unit is operating at full load.
2. Metals
CadmiumMethod 1Method 29aCompliance testing must be performed while the municipal waste combustion unit is operating at full load.
LeadMethod 1Method 29aCompliance testing must be performed while the municipal waste combustion unit is operating at full load.
MercuryMethod 1Method 29aCompliance testing must be performed while the municipal waste combustion unit is operating at full load.
OpacityMethod 9Method 9Use Method 9 to determine compliance with opacity limits. 3-hour observation period (thirty 6-minute averages).
Particulate MatterMethod 1Method 5 or 29The minimum sample volume must be 1.0 cubic meters. The probe and filter holder heating systems in the sample train must be set to provide a gas temperature no greater than 160 ±14 °C. The minimum sampling time is 1 hour.
3. Acid Gasesb
Hydrogen ChlorideMethod 1Method 26 or 26AaTest runs must be at least 1 hour long while the municipal waste combustion unit is operating at full load.
4. Otherb
Fugitive AshNot applicableMethod 22 (visible emissions)The three 1-hour observation period must include periods when the facility transfers fugitive ash from the municipal waste combustion unit to the area where the fugitive ash is stored or loaded into containers or trucks.

a Must simultaneously measure oxygen (or carbon dioxide) using Method 3A or 3B in appendix A of this part.

b Use CEMS to test sulfur dioxide, nitrogen oxide, and carbon monoxide. Stack tests are not required except for quality assurance requirements in appendix F of this part.

40 C.F.R. 60 app Table 8 to Subpart BBBB of Part 60