Subpart CC - CRANES AND DERRICKS IN CONSTRUCTION
- Appendix A to Subpart CC of Part 1926 - Standard Hand Signals
- Appendix B to Subpart CC of Part 1926 - Assembly/Disassembly: Sample Procedures for Minimizing the Risk of Unintended Dangerous Boom Movement
- Section 1926.1400 - Scope
- Section 1926.1401 - Definitions
- Section 1926.1402 - Ground conditions
- Section 1926.1403 - Assembly/Disassembly-selection of manufacturer or employer procedures
- Section 1926.1404 - Assembly/Disassembly-general requirements (applies to all assembly and disassembly operations)
- Section 1926.1405 - Disassembly-additional requirements for dismantling of booms and jibs (applies to both the use of manufacturer procedures and employer procedures)
- Section 1926.1406 - Assembly/Disassembly-employer procedures-general requirements
- Section 1926.1407 - Power line safety (up to 350 kV)-assembly and disassembly
- Section 1926.1408 - Power line safety (up to 350 kV)-equipment operations
- Section 1926.1409 - Power line safety (over 350 kV)
- Section 1926.1410 - Power line safety (all voltages)-equipment operations closer than the Table A zone
- Section 1926.1411 - Power line safety-while traveling under or near power lines with no load
- Section 1926.1412 - Inspections
- Section 1926.1413 - Wire rope-inspection
- Section 1926.1414 - Wire rope-selection and installation criteria
- Section 1926.1415 - Safety devices
- Section 1926.1416 - Operational aids
- Section 1926.1417 - Operation
- Section 1926.1418 - Authority to stop operation
- Section 1926.1419 - Signals-general requirements
- Section 1926.1420 - Signals-radio, telephone or other electronic transmission of signals
- Section 1926.1421 - Signals-voice signals-additional requirements
- Section 1926.1422 - Signals-hand signal chart
- Section 1926.1423 - Fall protection
- Section 1926.1424 - Work area control
- Section 1926.1425 - Keeping clear of the load
- Section 1926.1426 - Free fall and controlled load lowering
- Section 1926.1427 - Operator training, certification, and evaluation
- Section 1926.1428 - Signal person qualifications
- Section 1926.1429 - Qualifications of maintenance & repair employees
- Section 1926.1430 - Training
- Section 1926.1431 - Hoisting personnel
- Section 1926.1432 - Multiple-crane/derrick lifts-supplemental requirements
- Section 1926.1433 - Design, construction and testing
- Section 1926.1434 - Equipment modifications
- Section 1926.1435 - Tower cranes
- Section 1926.1436 - Derricks
- Section 1926.1437 - Floating cranes/derricks and land cranes/derricks on barges
- Section 1926.1438 - Overhead & gantry cranes
- Section 1926.1439 - Dedicated pile drivers
- Section 1926.1440 - Sideboom cranes
- Section 1926.1441 - Equipment with a rated hoisting/lifting capacity of 2,000 pounds or less
- Section 1926.1442 - Railroad roadway maintenance machines
- Section 1926.1443 - Severability
- Appendix C to Subpart CC of Part 1926 - Operator Certification: Written Examination: Technical Knowledge Criteria