Section 1406.5 - Performance and technical data to be furnished to the CommissionManufacturers, including importers, of coal and wood burning appliances as defined in § 1406.3(a) shall provide to the Commission the following performance and technical data related to performance and safety.
(a)Written notice. Manufacturers shall provide to the Commission copies of the written notice required by § 1406.4(a) . If the written notice is provided to purchasers in a way, such as by casting or stamping the notice into the stove, that makes it impractical to furnish a sample of the actual notice to the Commission, the manufacturer will provide an actual-size copy of the notice and a description of the forming process.(b)Directions. Manufacturers shall provide to the Commission a copy of the directions required by § 1406.4(b) .(c)Rationale. Manufacturers shall provide to the Commission a statement of how the distances to combustibles required to be stated by § 1406.4(a)(1) were determined. In addition, the maufacturer will state the type of appliance, its fuel, size, and weight, and the material of which it is constructed, unless this information is included in the directions submitted under paragraph (b) of this section.(d)General.(1) The information required to be submitted under paragraphs (a) through (c) of this section shall be submitted for each distinct design or model of appliance manufactured. An appliance will be considered to be a distinct design or model if it differs from other appliances of the same manufacturer by functional differences such as performance, weight, size, or capacity. Differences in cosmetic or other nonfunctional features do not require the submission of additional information.(2) The written notice, directions, and rationale shall be provided to the Assistant Executive Director for Compliance, Consumer Product Safety Commission, Washington, DC 20207, by December 6, 1983. If there is a subsequent change in the component materials or design features of a model for which this information was previously submitted that could cause the model to require different clearances from combustibles or a different type of chimney, or if a new product is introduced into United States commerce, the required information shall be submitted within 30 days after the change or introduction.48 FR 50706, Nov. 3, 1983, as amended at 62 FR 46667, Sept. 4, 1997 Approved by Office of Management and Budget under control number 3041-0040