Section 1604.30 - Revision of American National Standards Referred to in this Document(a) When the following American National Standards referred to in this document are superseded by a revision approved by the American National Standards Institute, Inc., the revision shall apply: (1) American National Standard Building Code Requirements for Reinforced Concrete, A89.1-1972 (ACI 318-71).(2) American National Standard Specification for Low and Intermediate Tensile Strength Carbon Steel Plates of Structural Quality, G24.2-1972 (ASTM A283-70a).(3) American National Standard Specification for Quenched and Tempered Alloy Steel Bolts or Structural Steel Joints, G24.19-1972 (ASTM A490-71).(4) American National Standard Specification for Low Carbon Steel Externally and Internally Threaded Standard Fasteners, G28.5-1969 (ASTM A307.68).(5) American National Standard Specification for High-Strength Bolts for Structural Steel Joints, including Suitable Nuts and Plain Hardened Washers, G38.6-1972 (ASTM A325-71a).(6) American National Standard Specification for Structural Steel, G41.5-1970 (ASTM A325-69).(7) American National Standard Specification for Steel Structural Rivets, G42.2-1968 (ASTM A502.65).(8) American National Standard Specification for Mild to Medium Strength Carbon Steel Castings for General Application, G50.1-1972 (ASTM A27-71).(9) American National Standard Specification for Carbon Steel Forgings for General Industrial Use, G55.20-1969 (ASTM A235-67).(10) American National Standard Methods of Static Tests of Timbers in Structural Sizes, 04.2-1969 (ASTM D198-67).(11) American National Standard Methods for Establishing Structural Grades for Visually Graded Lumber, 04.3-1969 (ASTM D245-68T).(12) American National Standard Safety in Welding and Cutting, Z49.1-1973.Cal. Code Regs. Tit. 8, § 1604.30