Cal. Code Regs. tit. 22 § 66270.24

Current through Register 2024 Notice Reg. No. 45, November 8, 2024

Section 66270.24 - Specific Part B Information Requirements for Process Vents

Except as otherwise provided in Section 66264.1, owners and operators of facilities that have process vents to which Article 27 of Chapter 14 applies must provide the following additional information:

(a) For facilities that cannot install a closed-vent system and control device to comply with the provisions of 40 CFR 264 subpart AA on the effective date that the facility becomes subject to the provisions of Chapter 14 or 15 Article 27, an implementation schedule as specified in Section 66264.1033(a)(2).

(b) Documentation of compliance with the process vent standards in Section 66264.1032, including:

(1) information and data identifying all affected process vents, annual throughput and operating hours of each affected unit, estimated emission rates for each affected vent and for the overall facility (i.e., the total emissions for all affected vents at the facility), and the approximate location within the facility of each affected unit (e.g., identify the hazardous waste management units on a facility plot plan);

(2) information and data supporting estimates of vent emissions and emission reduction achieved by add-on control devices based on engineering calculations or source tests. For the purpose of determining compliance, estimates of vent emissions and emission reductions must be made using operating parameter values (e.g., temperatures, flow rates, or concentrations) that represent the conditions that exist when the waste management unit is operating at the highest load or capacity level reasonably expected to occur; and

(3) information and data used to determine whether or not a process vent is subject to the requirements of Section 264.1032.

(c) An owner or operator who applies for permission to use a control device other than a thermal vapor incinerator, catalytic vapor incinerator, flare, boiler, process heater, condenser, or carbon adsorption system to comply with the requirements of Section 66264.1032, and chooses to use test data to determine the organic removal efficiency or the total organic compound concentration achieved by the control device, shall provide a performance test plan as specified in Section 66264.1035(b)(3).

(d) Documentation of compliance with Section 66264.1033, including:

(1) a list of all information references and sources used in preparing the documentation;

(2) records, including the dates of each compliance test required by Section 66264.1033(k);

(3) a design analysis, specifications, drawings, schematics, and piping and instrumentation diagrams based on the appropriate sections of "APTI Course 415: Control of Gaseous Emissions" (incorporated by reference as specified in Section 66260.11) or other engineering texts which the Department determines contain basic control device design information which is at least as protective of human health and the environment as APTI Course 415: Control of Gaseous Emissions. The design analysis shall address the vent stream characteristics and control device operation parameters as specified in Section 66264.1035(b)(4)(C);

(4) a statement signed and dated by the owner or operator certifying that the operating parameters used in the design analysis reasonably represent the conditions that exist when the hazardous waste management unit is or would be operating at the highest load or capacity level reasonably expected to occur; and

(5) a statement signed and dated by the owner or operator certifying that the control device is designed to operate at an efficiency of 95 weight percent or greater unless the total organic emission limits of Section 66264.1032(a) for affected process vents at the facility can be attained by a control device involving vapor recovery at an efficiency less than 95 weight percent.

Cal. Code Regs. Tit. 22, § 66270.24

1. New section filed 12-23-92; operative 1-22-93 (Register 93, No. 2).
2. Change without regulatory effect amending subsections (b)(2), (c), (d)(2) and (d)(3) filed 12-28-93 pursuant to title 1, section 100, California Code of Regulations (Register 93, No. 53).
3. Editorial correction of subsection (d)(4) (Register 95, No. 50).
4. Change without regulatory effect amending subsections (d)(2)-(3) filed 12-28-95 pursuant to section 100, title 1, California Code of Regulations (Register 95, No. 52).

Note: Authority cited: Sections 25150 and 25159, Health and Safety Code. Reference: Sections 25159 and 25159.5, Health and Safety Code; 40 CFR Section 270.24.