Ala. Admin. Code r. 335-14-2-.09
Current through Register Vol. 43, No. 1, October 31, 2024
Section 335-14-2-.09 - Use And Management Of Containers(1) Applicability. 335-14-2-.09 applies to hazardous secondary materials excluded under the remanufacturing exclusion at 335-14-2-.01(4)(a)27. and stored in containers.(2) Condition of containers. If a container holding hazardous secondary material is not in good condition (e.g., severe rusting, apparent structural defects) or if it begins to leak, the hazardous secondary material must be transferred from this container to a container that is in good condition or managed in some other way that complies with the requirements of 335-14-2-.09.(3) Compatibility of hazardous secondary materials with containers. The container must be made of or lined with materials which will not react with, and are otherwise compatible with, the hazardous secondary material to be stored, so that the ability of the container to contain the material is not impaired.(4) Management of containers (a) A container holding hazardous secondary material must always be closed during storage, except when it is necessary to add or remove the hazardous secondary material.(b) A container holding hazardous secondary material must not be opened, handled, or stored in a manner which may rupture the container of cause it to leak.(6) Containment (a) Container storage areas must have a containment system that is designed and operated in accordance with 335-14-2-.09(6)(b).(b) A containment system must be designed and operated as follows: 1. A base must underlie the containers which is free of cracks or gaps and is sufficiently impervious to contain leaks, spills, and accumulated precipitation until the collected material is detected and removed;2. The base must be sloped or the containment system must be otherwise designed and operated to drain and remove liquids resulting from leaks, spills, or precipitation, unless the containers are elevated or are otherwise protected from contact with accumulated liquids;3. The containment system must have sufficient capacity to contain 10% of the volume of containers or the volume of the largest container, whichever is greater.4. Run-on into the containment system must be prevented unless the collection system has sufficient excess capacity in addition to that required in 335-14-2-.09(6)(b)(3) to contain any run-on which might enter the system; and5. Spilled or leaked material and accumulated precipitation must be removed from the sump or collection area in as timely a manner as is necessary to prevent overflow of the collection system.(7) Special requirements for ignitable or reactive hazardous secondary material. Containers holding ignitable or reactive hazardous secondary material must be located at least 15 meters (50 feet) from the facility's property line.(8) Special requirements for incompatible materials. (a) Incompatible materials must not be placed in the same container.(b) Hazardous secondary material must not be placed in an unwashed container that previously held an incompatible material.(c) A storage container holding a hazardous secondary material that is incompatible with any other materials stored nearby must be separated from the other materials or protected from them by means of a dike, berm, wall, or other device.(10) Air emission standards. The remanufacturer or other person that stores or treats the hazardous secondary material shall manage all hazardous secondary material placed in a container in accordance with the applicable requirements of 335-14-2-.27, 335-14-2-.28, and 335-14-2-.29.Ala. Admin. Code r. 335-14-2-.09
Amended by Alabama Administrative Monthly Volume XXXIV, Issue No. 05, February 29, 2016, eff. 4/8/2016.Amended by Alabama Administrative Monthly Volume XXXVIII, Issue No. 05, February 28, 2020, eff. 4/13/2020.Amended by Alabama Administrative Monthly Volume XLI, Issue No. 07, April 28, 2023, eff. 6/12/2023.Author: Bradley N. Curvin, Sonja B. Favors, Brent A. Watson. Jonah L. Harris.
Statutory Authority:Code of Ala. 1975, §§ 22-30-11.