Airworthiness Directives; The Boeing Company Airplanes

AGENCY:

Federal Aviation Administration (FAA), DOT.

ACTION:

Notice of proposed rulemaking (NPRM).

SUMMARY:

We propose to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 767-200 and -300 series airplanes. This proposed AD was prompted by a report of a fire in the bilge area of the cargo compartment that burned through the insulation blankets that were intended to prevent smoke from migrating behind the cargo compartment sidewall liners and upward into the main cabin. This proposed AD would require replacing the cargo compartment insulation blankets on the left and right sides with new insulation blankets that incorporate fire stops. We are proposing this AD to prevent a fire in the bilge area of the cargo compartment burning through the insulation blankets and consequently allowing smoke to migrate behind the cargo compartment sidewall liners and upward into the main cabin.

DATES:

We must receive comments on this proposed AD by October 14, 2016.

ADDRESSES:

You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:

• Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
• Fax: 202-493-2251.
• Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
• Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

For service information identified in this NPRM, contact Boeing Commercial Airplanes, Attention: Data & Services Management, P.O. Box 3707, MC 2H-65, Seattle, WA 98124-2207; telephone 206-544-5000, extension 1; fax 206-766-5680; Internet https://www.myboeingfleet.com. You may view this referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221. It is also available on the internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-8850.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-8850; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (phone: 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

FOR FURTHER INFORMATION CONTACT:

Francis Smith, Aerospace Engineer, Cabin Safety & Environmental Control Systems, ANM-150S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue SW., Renton, WA 98057-3356; phone: 425-917-6596; fax: 425-917-6590; email: francis.smith@faa.gov.

SUPPLEMENTARY INFORMATION:

Comments Invited

We invite you to send any written relevant data, views, or arguments about this proposal. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2016-8850; Directorate Identifier 2016-NM-031-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD because of those comments.

We will post all comments we receive, without change, to http://www.regulations.gov,, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.

Discussion

We have received a report of a fire in the bilge area of the cargo compartment that burned through the insulation blankets that were intended to prevent smoke from migrating behind the cargo compartment sidewall liners and upward into the main cabin. The airplane was delivered with a partial floor configuration in the cargo compartment, and later modified into a full floor configuration. This event showed that the insulation blankets installed are not adequate to prevent fire in the bilge area from migrating past the cargo compartment sidewall liners and allowing smoke into the main cabin. We have determined that some airplanes with the full floor configuration in the cargo compartment did not receive the insulation blankets with fire stops. This condition, if not corrected, could result in a fire in the bilge area of the cargo compartment burning through the insulation blankets, which could result in smoke migrating behind the cargo compartment sidewall liners and upward into the main cabin.

Related Service Information Under 1 CFR Part 51

We reviewed Boeing Special Attention Service Bulletin 767-25-0550, dated January 30, 2015. The service information describes procedures for replacing the cargo compartment insulation blankets on the left and right sides between stringers 29 and 33 with new insulation blankets that incorporate fire stops. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.

FAA's Determination

We are proposing this AD because we evaluated all the relevant information and determined the unsafe condition described previously is likely to exist or develop in other products of the same type designs.

Proposed AD Requirements

This proposed AD would require accomplishing the actions specified in the service information described previously. For information on the procedures, see this service information at http://www.regulations.gov by searching for and locating Docket No. FAA-2016-8850.

Costs of Compliance

We estimate that this proposed AD affects 26 airplanes of U.S. registry. We estimate the following costs to comply with this proposed AD:

According to the manufacturer, some of the costs of this proposed AD may be covered under warranty, thereby reducing the cost impact on affected individuals. We do not control warranty coverage for affected individuals. As a result, we have included all available costs in our cost estimate.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this proposed regulation:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),

(3) Will not affect intrastate aviation in Alaska, and

(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

The Proposed Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):

The Boeing Company: Docket No. FAA-2016-8850; Directorate Identifier 2016-NM-031-AD.

(a) Comments Due Date

We must receive comments by October 14, 2016.

(b) Affected ADs

None.

(c) Applicability

This AD applies to The Boeing Company Model 767-200 and -300 series airplanes, certificated in any category, as identified in Boeing Special Attention Service Bulletin 767-25-0550, dated January 30, 2015.

(d) Subject

Air Transport Association (ATA) of America Code 25; Equipment/furnishings.

(e) Unsafe Condition

This AD was prompted by a report of a fire in the bilge area of the cargo compartment that burned through the insulation blankets that were intended to prevent smoke from migrating behind the cargo compartment sidewall liners and upward into the main cabin. We are issuing this AD to prevent a fire in the bilge area of the cargo compartment burning through the insulation blankets and consequently allowing smoke to migrate behind the cargo compartment sidewall liners and upward into the main cabin.

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Insulation Blanket Replacement

Within 36 months after the effective date of this AD: Replace the cargo compartment insulation blankets on the left and right sides between stringers 29 and 33 with new insulation blankets that incorporate fire stops, in accordance with the Accomplishment Instructions of Boeing Special Attention Service Bulletin 767-25-0550, dated January 30, 2015. For Groups 1 through 4, Configurations 1 and 2 airplanes identified in Boeing Special Attention Service Bulletin 767-25-0550, dated January 30, 2015, no action is required by this AD.

(h) Alternative Methods of Compliance (AMOCs)

(1) The Manager, Seattle Aircraft Certification Office (ACO), FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the ACO, send it to the attention of the person identified in paragraph (i)(1) of this AD. Information may be emailed to: 9-ANM-Seattle-ACO-AMOC-Requests@faa.gov.

(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.

(3) An AMOC that provides an acceptable level of safety may be used for any repair, modification, or alteration required by this AD if it is approved by the Boeing Commercial Airplanes Organization Designation Authorization (ODA) that has been authorized by the Manager, Seattle ACO, to make those findings. To be approved, the repair method, modification deviation, or alteration deviation must meet the certification basis of the airplane, and the approval must specifically refer to this AD.

(4) For service information that contains steps that are labeled as Required for Compliance (RC), the provisions of paragraphs (h)(4)(i) and (h)(4)(ii) of this AD apply.

(i) The steps labeled as RC, including substeps under an RC step and any figures identified in an RC step, must be done to comply with the AD. An AMOC is required for any deviations to RC steps, including substeps and identified figures.

(ii) Steps not labeled as RC may be deviated from using accepted methods in accordance with the operator's maintenance or inspection program without obtaining approval of an AMOC, provided the RC steps, including substeps and identified figures, can still be done as specified, and the airplane can be put back in an airworthy condition.

(i) Related Information

(1) For more information about this AD, contact Francis Smith, Aerospace Engineer, Cabin Safety & Environmental Control Systems, ANM-150S, FAA, Seattle ACO, 1601 Lind Avenue SW., Renton, WA 98057-3356; phone: 425-917-6596; fax: 425-917-6590; email: francis.smith@faa.gov.

(2) For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Data & Services Management, P.O. Box 3707, MC 2H-65, Seattle, WA 98124-2207; telephone 206-544-5000, extension 1; fax 206-766-5680; Internet https://www.myboeingfleet.com. You may view this referenced service information at the FAA, the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.