Airworthiness Directives; Airbus Helicopters

AGENCY:

Federal Aviation Administration (FAA), DOT.

ACTION:

Notice of proposed rulemaking (NPRM).

SUMMARY:

The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus Helicopters Model EC155B1 helicopters. This proposed AD was prompted by a report of difficulties when jettisoning the co-pilot door during non-scheduled maintenance. This proposed AD would require a functional check of the pilot and co-pilot door jettisoning system and corrective actions if necessary, as specified in a European Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.

DATES:

The FAA must receive comments on this proposed AD by May 24, 2021.

ADDRESSES:

You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:

• Federal eRulemaking Portal: Go to https://www.regulations.gov. Follow the instructions for submitting comments.
• Fax: 202-493-2251.
• Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590.
• Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

For material that is proposed for IBR in this AD, contact the EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email ADs@easa.europa.eu; internet www.easa.europa.eu. You may find this material on the EASA website at https://ad.easa.europa.eu. You may view this material at the FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood Pkwy., Room 6N-321, Fort Worth, TX 76177. For information on the availability of this material at the FAA, call 817-222-5110. It is also available in the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2021-0314.

Examining the AD Docket

You may examine the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2021-0314; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this NPRM, any comments received, and other information. The street address for Docket Operations is listed above. Comments will be available in the AD docket shortly after receipt.

FOR FURTHER INFORMATION CONTACT:

Kathleen Arrigotti, Program Manager, Large Aircraft Section, International Validation Branch, Compliance & Airworthiness Division, FAA, 2200 South 216th St., Des Moines, WA 98198; telephone and fax 206-231-3218; email kathleen.arrigotti@faa.gov.

SUPPLEMENTARY INFORMATION:

Comments Invited

The FAA invites you to send any written relevant data, views, or arguments about this proposal. Send your comments to an address listed under ADDRESSES. Include “Docket No. FAA-2021-0314; Project Identifier MCAI-2020-00599-R” at the beginning of your comments. The most helpful comments reference a specific portion of the proposal, explain the reason for any recommended change, and include supporting data. The FAA will consider all comments received by the closing date and may amend this proposal because of those comments.

Except for Confidential Business Information (CBI) as described in the following paragraph, and other information as described in 14 CFR 11.35, the FAA will post all comments received, without change, to https://www.regulations.gov,, including any personal information you provide. The agency will also post a report summarizing each substantive verbal contact received about this proposal.

Confidential Business Information

CBI is commercial or financial information that is both customarily and actually treated as private by its owner. Under the Freedom of Information Act (FOIA) (5 U.S.C. 552), CBI is exempt from public disclosure. If your comments responsive to this NPRM contain commercial or financial information that is customarily treated as private, that you actually treat as private, and that is relevant or responsive to this NPRM, it is important that you clearly designate the submitted comments as CBI. Please mark each page of your submission containing CBI as “PROPIN.” The FAA will treat such marked submissions as confidential under the FOIA, and they will not be placed in the public docket of this NPRM. Submissions containing CBI should be sent to Kathleen Arrigotti, Program Manager, Large Aircraft Section, International Validation Branch, Compliance & Airworthiness Division, FAA, 2200 South 216th St., Des Moines, WA 98198; telephone and fax 206-231-3218; email kathleen.arrigotti@faa.gov. Any commentary that the FAA receives that is not specifically designated as CBI will be placed in the public docket for this rulemaking.

Discussion

The EASA (now European Union Aviation Safety Agency), which is the Technical Agent for the Member States of the European Union, has issued EASA AD 2015-0157, dated July 30, 2015 (EASA AD 2015-0157) (also referred to as the Mandatory Continuing Airworthiness Information, or the MCAI), to correct an unsafe condition for Airbus Helicopters Model EC 155 B1 helicopters, all serial numbers delivered after manufacturing before June 30, 2015, and equipped with a pilot or co-pilot door jettisoning system in accordance with Airbus Helicopters Modification POST MOD 0752C05, except helicopters on which Aircraft Maintenance Manual (AMM) Task 52-11-00-712 was accomplished on both pilot and co-pilot doors since the last crew door installation.

This proposed AD was prompted by a report of difficulties when jettisoning the co-pilot door during non-scheduled maintenance. The FAA is proposing this AD to address jamming of the affected door jettisoning mechanism, which could reduce the ability of the flightcrew to evacuate in the event of an emergency situation. See the MCAI for additional background information.

Related IBR Material Under 1 CFR Part 51

EASA AD 2015-0157 describes procedures for doing a functional check of the pilot and co-pilot door jettisoning system and corrective actions. The corrective actions include greasing the tenons and restoring the jettison system. This material is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.

FAA's Determination and Requirements of This Proposed AD

This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to the bilateral agreement with the State of Design Authority, the FAA has been notified of the unsafe condition described in the MCAI referenced above. The FAA is proposing this AD after evaluating all the relevant information and determining the unsafe condition described previously is likely to exist or develop in other products of the same type design.

Proposed AD Requirements

This proposed AD would require accomplishing the actions specified in EASA AD 2015-0157, described previously, as incorporated by reference, except for any differences identified as exceptions in the regulatory text of this proposed AD.

Explanation of Required Compliance Information

In the FAA's ongoing efforts to improve the efficiency of the AD process, the FAA initially worked with Airbus and EASA to develop a process to use certain EASA ADs as the primary source of information for compliance with requirements for corresponding FAA ADs. The FAA has since coordinated with other manufacturers and civil aviation authorities (CAAs) to use this process. As a result, EASA AD 2015-0157 will be incorporated by reference in the FAA final rule. This proposed AD would, therefore, require compliance with EASA AD 2015-0157 in its entirety, through that incorporation, except for any differences identified as exceptions in the regulatory text of this proposed AD. Using common terms that are the same as the heading of a particular section in the EASA AD does not mean that operators need comply only with that section. For example, where the AD requirement refers to “all required actions and compliance times,” compliance with this AD requirement is not limited to the section titled “Required Action(s) and Compliance Time(s)” in the EASA AD. Service information specified in EASA AD 2015-0157 that is required for compliance with EASA AD 2015-0157 will be available on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2021-0314 after the FAA final rule is published.

Costs of Compliance

The FAA estimates that this proposed AD affects 14 helicopters of U.S. registry. The FAA estimates the following costs to comply with this proposed AD:

The FAA estimates the following costs to do any necessary on-condition action that would be required based on the results of any required actions. The FAA has no way of determining the number of helicopters that might need this on-condition action:

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.

The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

The FAA determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this proposed regulation:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Would not affect intrastate aviation in Alaska, and

(3) Would not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

The Proposed Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

2. The FAA amends § 39.13 by adding the following new airworthiness directive:

Airbus Helicopters: Docket No. FAA-2021-0314; Project Identifier MCAI-2020-00599-R.

(a) Comments Due Date

The FAA must receive comments by May 24, 2021.

(b) Affected Airworthiness Directives (ADs)

None.

(c) Applicability

This AD applies to Airbus Helicopters Model EC155B1 helicopters, certificated in any category, all serial numbers manufactured before June 30, 2015, and equipped with a pilot or co-pilot door jettisoning system in accordance with Airbus Helicopters modification POST MOD 0752C05, except helicopters on which Aircraft Maintenance Manual (AMM) task 52-11-00-712 was accomplished on both pilot and co-pilot doors since the last crew door installation.

(d) Subject

Joint Aircraft System Component (JASC) Code 5210, Passenger/Crew Doors.

(e) Reason

This AD was prompted by a report of difficulties when jettisoning the co-pilot door during non-scheduled maintenance. The FAA is issuing this AD to address jamming of the affected door jettisoning mechanism, which could reduce the ability of the flightcrew to evacuate in the event of an emergency situation.

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Requirements

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with European Aviation Safety Agency (now European Union Aviation Safety Agency) (EASA) AD 2015-0157, dated July 30, 2015 (EASA AD 2015-0157).

(h) Exceptions to EASA AD 2015-0157

(1) Where EASA AD 2015-0157 refers to its effective date, this AD requires using the effective date of this AD.

(2) The “Remarks” section of EASA AD 2015-0157 does not apply to this AD.

(3) Where EASA AD 2015-0157 refers to flight hours (FH), this AD requires using hours time-in-service.

(4) Where paragraph (2) of EASA AD 2015-0157 provides an option to contact Airbus Helicopters for approved instructions and accomplish those instructions, for this AD, the option is to repair the jettison system in accordance with FAA-approved procedures.

(5) Where the service information referenced in EASA AD 2015-0157 specifies to “speak to Airbus Helicopters,” this AD requires repairing the jettison system in accordance with FAA-approved procedures.

(6) Where the service information referenced in EASA AD 2015-0157 specifies to discard certain parts, this AD requires removing the parts from service instead.

(i) Alternative Methods of Compliance (AMOCs)

(1) The Manager, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the Manager of the International Validation Branch, send it to: Manager, International Validation Branch, FAA, 10101 Hillwood Pkwy., Fort Worth, TX 76177; telephone (817) 222-5110; email 9-AVS-AIR-730-AMOC@faa.gov.

(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.

(j) Related Information

(1) For EASA AD 2015-0157, contact the EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email ADs@easa.europa.eu; internet www.easa.europa.eu. You may find this EASA AD on the EASA website at https://ad.easa.europa.eu. You may view this material at the FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood Pkwy., Room 6N-321, Fort Worth, TX 76177. For information on the availability of this material at the FAA, call 817-222-5110. This material may be found in the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2021-0314.

(2) For more information about this AD, contact Kathleen Arrigotti, Program Manager, Large Aircraft Section, International Validation Branch, Compliance & Airworthiness Division, FAA, 2200 South 216th St., Des Moines, WA 98198; telephone and fax 206-231-3218; email kathleen.arrigotti@faa.gov.