Okla. Admin. Code § 165:15-9-2
Current through Vol. 42, No. 4, November 1, 2024
Section 165:15-9-2 - Display on dispenser(a) Every dispenser or delivery device regulated by the Commission used for sale of motor fuel to the public must have a label that clearly identifies every type of motor fuel offered for sale.(b) Motor fuel containing fifteen percent (15%) ethanol, commonly referred to as E15, must be labeled as the following: The label is 3.625 inches (9.20 cm) wide x 3.125 inches (7.93 cm) long. "Helvetica Black" or equivalent type is used throughout. Use black letters on an orange background for the lower portion and the diagonal "Attention" field and use orange letters on a black background for the rest of the upper portion. Set vertical position and line spacing as appropriate for each field. The band at the top of the label contains the following:(1) The band should measure 1.25 inch (3.175 cm) deep. The type in the band is centered both horizontally and vertically. The first line is the text "E15" and is in 42-point font. The second line is in 14-point font, at least 1/8 inch (.32 cm) below the first line and is in the text "Up to 15% ethanol".(2) The type below the black band is left-justified. The first line is the text: "Use only in" and is in 20-point font. The second line is a bullet point, in 14-point font, at least 1/8 inch (.32 cm) below the first line and is the text: "2001 and newer passenger vehicles." The third line is a bullet point, in 14-point font, at least 1/8 inch (.32 cm) below the second line and is the text "Flex-fuel vehicles". The fourth line is in 12-point font, at least 1/8 inch (.32 cm) below the first line and is the text "Don't use in other vehicles, boats or gasoline-powered equipment. It may cause damage and is prohibited by Federal law." The word "prohibited" is bold and italic.(c) Any other motor fuel must be displayed in accordance with 16 CFR Part 306.0 through 306.12, including Appendices; and sold as provided by Commission rules and National Institute of Standards and Technology (NIST) Handbook 44, "Specifications, Tolerances, and Other Technical Requirements for Weighing and Measuring Devices".Okla. Admin. Code § 165:15-9-2
Amended at 9 Ok Reg 2329, eff 6-25-92; Amended at 13 Ok Reg 2405, eff 7-1-96; Amended at 18 Ok Reg 1052, eff 5-11-01; Amended at 21 Ok Reg 2029, eff 7-1-04Amended by Oklahoma Register, Volume 31, Issue 24, September 2, 2014, eff. 9/12/2014Amended by Oklahoma Register, Volume 35, Issue 24, September 4, 2018, eff. 10/1/2018Amended by Oklahoma Register, Volume 41, Issue 23, August 15, 2024, eff. 10/1/2024