Section 60-300.45 - Benchmarks for hiringThe benchmark is not a rigid and inflexible quota which must be met, nor is it to be considered either a ceiling or a floor for the employment of particular groups. Quotas are expressly forbidden.
(a)Purpose: The purpose of establishing benchmarks is to create a quantifiable method by which the contractor can measure its progress toward achieving equal employment opportunity for protected veterans.(b) Hiring benchmarks shall be set by the contractor on an annual basis. Benchmarks shall be set using one of the two mechanisms described below:(1) Establish a benchmark equaling the national percentage of veterans in the civilian labor force, which will be published and updated annually on the OFCCP Web site; or(2) Establish a benchmark by taking into account:(i) The average percentage of veterans in the civilian labor force in the State(s) where the contractor is located over the preceding three years, as calculated by the Bureau of Labor Statistics and published on the OFCCP Web site;(ii) The number of veterans, over the previous four quarters, who were participants in the employment service delivery system in the State where the contractor is located, as tabulated by the Veterans' Employment and Training Service and published on the OFCCP Web site;(iii) The applicant ratio and hiring ratio for the previous year, based on the data collected pursuant to § 60-300.44(k);(iv) The contractor's recent assessments of the effectiveness of its external outreach and recruitment efforts, as set forth in § 60-300.44(f)(3); and(v) Any other factors, including but not limited to the nature of the contractor's job openings and/or its location, which would tend to affect the availability of qualified protected veterans.(c) The contractor shall document the hiring benchmark it has established each year. If the contractor sets its benchmark using the procedure in paragraph (b)(2) of this section, it shall document each of the factors that it considered in establishing the hiring benchmark and the relative significance of each of these factors. The contractor shall retain these records for a period of three (3) years.