From Casetext: Smarter Legal Research

Tool v. Boutelle

Supreme Court, Albany County
Sep 19, 1977
91 Misc. 2d 464 (N.Y. Sup. Ct. 1977)

Summary

In Tool, which was an action for the malpractice of an engineer-surveyor, "[c]ontinuity" was defined as "being continuous... state of continuing without essential change."

Summary of this case from CROWN CASTLE USA INC. v. FRED A. NUDD CORPORATION

Opinion

September 19, 1977

William J. Schoonmaker for defendant.

Lester R. Rubin for plaintiff.


This is a motion by defendant for summary judgment dismissing the complaint upon the ground that the action is barred by the Statute of Limitations.

The complaint sets forth a cause of action in malpractice against the defendant for negligently performing engineering and surveying services. The services consisted of preparing a survey of plaintiff's property for the purpose of establishing and confirming property lines and building locations. Although the services were performed in 1967, the alleged error of the defendant was not discovered until November, 1975. In his affidavit in opposition to this motion, plaintiff states that in June, 1972 he engaged the defendant to revise the survey completed in 1967, and that in 1975 defendant was again engaged to revise the prior surveys. Plaintiff contends that because of this continuation of the professional relationship, the Statute of Limitations did not begin to run until the termination of that relationship.

The defendant's versions of the facts are set forth in his bill of particulars and in his reply affidavit. It appears that prior to 1975 defendant did perform surveying services for plaintiff on the same property on which he did the initial survey, but he asserts that these services did not pertain to the alleged error. Thus, in 1968 defendant set some stakes on the property, in 1972 he located a vestibule on the building, and in 1973 he made some prints for the plaintiff.

In the latter part of 1975 the alleged error was discovered. According to the plaintiff's bill of particulars, the plot plan was incorrect, the building setback was incorrect and the description was incorrect. At this time defendant agreed to do the necessary work to correct the error and did, in fact, perform this work.

The issue before the court is whether, upon these facts, the Statute of Limitations is a bar to plaintiff's action for malpractice based upon the error made in 1967.

The applicable Statute of Limitations period in an action for malpractice is three years (CPLR 214, subd 6) and the cause of action accrues upon the performance of the work by the professional (Sosnow v Paul, 43 A.D.2d 978, affd 36 N.Y.2d 780). The "continuous treatment" exception upon which plaintiff relies holds that when a course of treatment by a professional which includes wrongful acts and omissions has been continuous and is related to the original condition or complaint, the claim accrues at the end of the treatment (Borgia v City of New York, 12 N.Y.2d 151). Although the doctrine was originally formulated in a medical malpractice action, it has been applied in actions against other professionals, such as attorneys, accountants and architects (see Dura-Bilt Remodelers v Albanese, 86 Misc.2d 172).

Where applicable, the doctrine of "continuous treatment" suspends accrual of the malpractice cause of action until treatment ends or the professional relationship is terminated. However, the "continuous treatment" must be a treatment for the same or related condition, continuing after the alleged acts of malpractice; not mere continuity of a general professional relationship (see Naetzker v Brocton Cent. School Dist., 50 A.D.2d 142, 148, revd on other grounds 41 N.Y.2d 929; Dura-Bilt Remodelers v Albanese, supra).

In medical malpractice cases, continuous treatment is for a particular physical injury or illness (see, e.g., Fonda v Paulsen, 46 A.D.2d 540); in malpractice against attorneys, the attorney's subsequent services must be related to a particular case (see, e.g., Dura-Bilt Remodelers v Albanese, supra); and in malpractice against architects, the architect's subsequent work must be related to a particular project (see, e.g., Naetzker v Brocton Cent. School Dist., supra). In malpractice against a surveyor, in order for the doctrine to apply, the subsequent work must be related to the original work for which the surveyor was engaged. Thus, if a surveyor performs unrelated work for a client on the same property, the rule would not apply. If the subsequent work, however, builds on, expands or integrates the initial work, then the rule would be applicable.

In the present case, the court finds that the defendant's work in 1968, 1972, 1973 and 1975 was related to work performed by the defendant in 1967. But "relation" is not the only element which must be found in order for the doctrine to apply; there must also be "continuity" (see Borgia v City of New York, 12 N.Y.2d 151, 157, supra). If there is a three-year gap between the services performed by a professional, even though such services are related to the original condition or initial acts upon which the malpractice is predicated, then the Statute of Limitations will have run (see Naetzker v Brocton Cent. School Dist., 50 A.D.2d 142, 149, revd on other grounds 41 N.Y.2d 929, supra; Fonda v Paulsen, 46 A.D.2d 540, 544, supra). Moreover, the engagement by a professional to review and rectify errors made previously does not revive the claim once the statute has run (see Naetzker v Brocton Cent. School Dist., supra). In the present case, there was a three-year gap between the services performed by defendant in 1968 and those performed in 1972; thus, the statute has run and plaintiff's claim is time-barred.

In medical malpractice causes of action, the Statute of Limitations has been reduced to two years and six months (CPLR 214-a).

The motion shall be granted, without costs.


Summaries of

Tool v. Boutelle

Supreme Court, Albany County
Sep 19, 1977
91 Misc. 2d 464 (N.Y. Sup. Ct. 1977)

In Tool, which was an action for the malpractice of an engineer-surveyor, "[c]ontinuity" was defined as "being continuous... state of continuing without essential change."

Summary of this case from CROWN CASTLE USA INC. v. FRED A. NUDD CORPORATION

In Tool v. Boutelle, 91 Misc.2d 464, 398 N.Y.S.2d 128 (1977), which was an action for the malpractice of an engineer-surveyor, there was a characterization of "continuous treatment": "[T]he `continuous treatment' must be a treatment for the same or related condition, continuing after the alleged acts of malpractice; not mere continuity of a general professional relationship.... But `relation' is not the only element which must be found in order for the doctrine to apply; there must also be `continuity'...."

Summary of this case from Lincoln Grain v. Coopers Lybrand
Case details for

Tool v. Boutelle

Case Details

Full title:WALTER J. TOOL, Plaintiff, v. LINDSAY M. BOUTELLE, Doing Business as…

Court:Supreme Court, Albany County

Date published: Sep 19, 1977

Citations

91 Misc. 2d 464 (N.Y. Sup. Ct. 1977)
398 N.Y.S.2d 128

Citing Cases

Tonegatto v. Budak

Under New York case law, where a period of time exceeding the statute of limitations elapses between visits…

Schoenrock v. Tappe

Furthermore, the application of this doctrine should only be applied where the "professional's involvement…