From Casetext: Smarter Legal Research

Royal v. Black and Decker Mfg. Co.

District Court of Appeal of Florida, Third District
Jan 10, 1968
205 So. 2d 307 (Fla. Dist. Ct. App. 1968)

Summary

holding that a manufacturer does not breach its duty when it has supplied materials that are reasonably safe, even though the materials might conceivably be made more safe

Summary of this case from Coba v. Tricam Indus., Inc.

Opinion

No. 66-527.

November 7, 1967. On Rehearing January 10, 1968.

Appeal from the Circuit Court for Dade County, J. Gwynn Parker, J.

Linet, Schwartz Klein, North Miami Beach, for appellant.

Blackwell, Walker Gray and William H. Dixon, Miami, for appellee.

Before CHARLES CARROLL, C.J., and BARKDULL and SWANN, JJ.


A construction worker at a construction site was electrocuted when he attempted to connect the plug of a power drill into an extension cord. The plug of the drill was apparently not unusual in any respect, but, allegedly, it could have been designed in such a fashion as to make more remote the possibility of a direct or accidental contact with the energized prongs.

From essentially these basic facts, the worker's widow launched a three-pronged attack against the manufacturer of the drill, seeking recovery, alternatively, upon the conventional theories of negligence and warranty, as well as the more recent notion of strict liability.

The question before us is whether these facts, if taken as true, are sufficient to sustain a recovery under any of these theories. The lower court thought not, and dismissed the action with prejudice. The widow then took the instant appeal.

The liability of a contracting party (particularly a manufacturer) to a third party, not a party to the contract, for injuries suffered from an imperfect performance of the contract has had a long and often told history.

Although, as Prosser points out, the action for breach of warranty originally "sounded in tort," it became traditionally one in contract after 1778. The landmark case of poor Mr. Winterbottom established the principle that no action could arise from the failure to perform a contract properly unless the plaintiff was in privity with the defendant. Actions by third parties in both contract and tort were thus thwarted by the requirement of privity.

Prosser, Torts § 95 (3rd Ed. 1964).

Winterbottom v. Wright, 10 M. W. 109, 152 Eng.Rep. 402 (1842).

And so, the actions for breach of warranty and negligence for injuries arising from an imperfectly performed contract ran parallel to each other until 1852, when tort liability irrespective of privity was imposed upon a poison labeler for negligently mislabeling a bottle which subsequently caused harm to an unsuspecting remote vendee. Thomas v. Winchester, 6 N.Y. 397, 57 Am. Dec. 455 (1852). This principle was later held to apply to products which, by nature of their defect, became "inherently dangerous." Devlin v. Smith, 89 N.Y. 470, 42 Am.Rep. 311 (1882), and more notably in MacPherson v. Buick Motor Co., 217 N.Y. 382, 111 N.E. 1050, L.R.A. 1916F, 696 (1916).

Privity had now been abandoned as the yardstick of foreseeability in negligence actions where the product, by its very nature, or by nature of its defect, was of substantial danger to those who might use it. The road was now divided into two distinct paths; warranty followed the path of contract and negligence followed the path of tort.

In recent years, the two paths have begun to merge once again. In 1931, Judge Cardozo sounded the alarm that "[t]he assault upon the citadel of privity" was proceeding apace and Dean Prosser has maintained the vigil. See Prosser, The Assault Upon the Citadel, 69 Yale L.J. 1099 (1960) and Prosser, The Fall of the Citadel, 50 Minn.L.Rev. 791 (1966). The age old doctrine of caveat emptor was gradually seen to have a limited utility in an age of highly sophisticated products when users are forced to rely without inspection or knowledge upon the competence and specialized knowledge of manufacturers. Courts have been cognizant, too, of the fact that the manufacturer or sponsors of a product were generally in a better position to absorb the economic burden of such losses and unmistakable trends were started to place the economic burden squarely upon the shoulders of the manufacturers. See Henningsen v. Bloomfield Motors, Inc., 32 N.J. 358, 161 A.2d 69, 75 A.L.R.2d 1 (1960).

Ultramares Corporation v. Touche, 255 N.Y. 170, 174 N.E. 441, 74 A.L.R. 1139 (1931).

See Keeton, Products Liability, 49 Va. L.Rev. 675 (1963); Keeton, Products Liability, — Liability Without Fault and the Requirement of a Defect, 41 Texas L.Rev. 855 (1963).

Strikingly similar results were achieved with an assortment of legal fictions and modifications in the application of the traditional rules governing express warranty, implied warranty, and negligence. Many new concepts were conceived, resulting in a hybrid conglomeration of terms, both contract and tort. At one point, some twenty-nine theories of recovery were counted, but these were refined and consolidated until the theory of strict liability evolved to complement the traditional warranty and negligence theories.

See the "twenty-nine such triumphs of juridical technique" which Prosser cites, thanks to the "Unusual industry of Mr. Cornelius W. Gillam." Prosser, The Assault Upon the Citadel, 69 Yale L.J. 1099, 1124 (1960).

Greenman v. Yuba Power Products, Inc., 59 Cal.2d 57, 27 Cal.Rptr. 697, 377 P.2d 897, 13 A.L.R.3d 1049 (1963).

Distinctions between the various doctrines of product liability as they presently exist frequently have more theoretical than practical significance. Whatever form of liability is pursued — whether it be negligence, warranty, or strict liability — certain common denominators are inescapable.

"* * * liability in most situations still depends on negligence, and, moreover, some of the problems involved in proving negligence are very much the same as those related to proof of a defect in a product that will constitute the basis for a finding of breach of an implied warranty." Keeton, Products Liability, 49 Va.L.Rev. 675, 676 (1963).

At the heart of each theory is the requirement that the plaintiff's injury must have been caused by some defect in the product. Generally, when the injury is in no way attributable to a defect, there is no basis for imposing product liability upon the manufacturer. It is not contemplated that a manufacturer should be made the insurer for all physical injuries caused by his products. See e.g. Restatement 2d, Torts, § 402A, comment g. Thus "courts that impose strict liability eliminating negligence as a requirement for recovery must adopt some rules or principles as a substitute for negligence as a delimiting principle."

Keeton, Products Liability — Liability Without Fault and the Requirement of a Defect, 41 Texas L.Rev. 855, 858 (1963).

So called "strict liability" in tort is to be imposed upon the manufacturer, in the words of Justice Traynor, "when an article he places on the market, knowing that it is to be used without inspection for defects, proves to have a defect that causes injury to a human being."

Greenman v. Yuba Power Products, Inc., 59 Cal.2d 57, 27 Cal.Rptr. 697, 700, 377 P.2d 897, 900 (1963).

What is a defect? How do we recognize the fatal flaw that imposes liability? An all-encompassing definition is elusive.

The Restatement suggests:

"* * * The article sold must be dangerous to an extent beyond that which would be contemplated by the ordinary consumer who purchases it, with the ordinary knowledge common to the community as to its characteristics. * * *" Restatement 2d, Torts, § 402A, comment i.

The primary concern is to protect the user from the unreasonably dangerous product or from one fraught with unexpected dangers. For more extended treatment of the concept of defect see Traynor, The Ways and Meanings of Defective Products and Strict Liability, 32 Tenn.L.Rev. 363 (1965); Freedman, "Defect" in the Product, 32 Tenn.L.Rev. 323 (1965). There is no requirement upon the manufacturer beyond this, however, to make an accident-proof or fool-proof product.

In the case at bar, the plaintiff has failed to allege any facts from which reasonable men might conclude that the plug was unreasonably dangerous or defective. No allegations of any latent characteristics are made or of any deviation from the norm, either in comparison with similar plugs or in comparison with those customarily used for similar purposes. There are similarly no allegations that the plug did not meet the standards of the industry or that its design contained a latent functional defect.

The plaintiff would have liability imposed for the failure to make the plug accident-proof. It is not in itself a breach of duty to supply materials which are reasonably safe and customarily used, even though the material might conceivably be made more safe, nor must the manufacturer make his product "more" safe when the danger to be avoided is obvious to all. See Evans v. General Motors Corporation, 359 F.2d 822 (7th Cir. 1966); Campo v. Scofield, 301 N.Y. 468, 95 N.E.2d 802 (1950).

See also Matthews v. Lawnlite Company, Fla. 1956, 88 So.2d 299, 301, wherein Justice Terrell, speaking for the court, stated: "An implied warranty does not protect against hazards apparent to the plaintiff; it protects against an unusual or apparent use. It does not protect against injury imposed while carelessly using a dangerous mechanism."

Accordingly, the order of dismissal is hereby

Affirmed.


ON REHEARING GRANTED


The court, having granted a petition for rehearing and after having heard further argument of counsel for the respective parties, adheres to the opinion heretofore filed.

It is so ordered.


Summaries of

Royal v. Black and Decker Mfg. Co.

District Court of Appeal of Florida, Third District
Jan 10, 1968
205 So. 2d 307 (Fla. Dist. Ct. App. 1968)

holding that a manufacturer does not breach its duty when it has supplied materials that are reasonably safe, even though the materials might conceivably be made more safe

Summary of this case from Coba v. Tricam Indus., Inc.

In Royal the appeal was from the dismissal of a complaint with prejudice; the complaint charged the manufacturer of a drill on the theories of negligence, implied warranty and strict liability in tort.

Summary of this case from Harrison v. McDonough Power Equipment, Inc.

In Royal v. Black and Decker Manufacturing Co. 205 So.2d 307 (3d D.C.A.Fla. 1967), the doctrine of strict liability in tort was recognized and discussed although the trial court was affirmed in its dismissal of the complaint for failure to allege facts from which reasonable men might conclude that the product under consideration was unreasonably dangerous or defective.

Summary of this case from Favors v. Firestone Tire Rubber Co.
Case details for

Royal v. Black and Decker Mfg. Co.

Case Details

Full title:LONA MAE ROYAL, APPELLANT, v. THE BLACK AND DECKER MANUFACTURING COMPANY…

Court:District Court of Appeal of Florida, Third District

Date published: Jan 10, 1968

Citations

205 So. 2d 307 (Fla. Dist. Ct. App. 1968)

Citing Cases

Farmhand, Inc. v. Brandies

"If the defect is discoverable by simple observation then the law will imply no warranty against its…

Cunningham v. General Motors Corp.

To recover on a strict liability theory, the user must establish (1) the manufacturer's relationship to the…